If any deformities are evident discard and do not reuse.* Inspect rubber and straps for wear and tear.TO REMOVE TRAC-GRABBERS FROM THE WHEELS, PUSH THEM BACK TO THEIR ORIGINAL POSITION ON THE TIRE TO CREATE SLACK IN THE STRAP. REMOVAL: The Trac-Grabbers will become very tight on the wheels during use.WITH TRAC-GRABBERS INSTALLED ON THE FRONT WHEELS, KEEP THE WHEELS AS STRAIGHT AS POSSIBLE. Try to avoid spinning the wheels as much as possible. As the vehicle begins to move, maintain steady but not excessive power until vehicle reaches stable terrain. Slowly apply more power to allow the Trac-Grabbers to lift and move vehicle. With TRAC-GRABBERS installed, slowly apply power until the tires rotate and engage the Trac-Grabbers.With Trac-Grabbers installed, DRIVE IN REVERSE or FORWARD, WHICHEVER IS THE DIRECTION OF LEAST RESISTANCE AND SHORTEST DIRECTION BACK TO STABLE TERRAIN.Clearing away any dirt, mud, or snow that may impede movement or create resistance to direction of travel from all four vehicle unstuck.ALSO inspect to make sure that there is adequate clearance between the strap and any stationary components of the vehicle for the strap to make a full and unobstructed rotation. Make sure that there is sufficient clearance between the wheel and the wheel well for the Trac-Grabber to make a full and unobstructed rotation. THOROUGHLY INSPECT WHEEL WELL TO MAKE SURE YOUR VEHICLE HAS SUFFICIENT CLEARANCES.Do not drive over 5 mph while Trac-Grabbers are installed.Loose Trac-Grabber may cause damage to the vehicle!DO NOT INSTALL STRAP THROUGH OPENING NEAR TIRE VALVE STEM! Feed the end of the strap through the “D” rings, PULL TIGHT, and secure the strap with the Velcro to prevent slippage. Feed the loose end of the strap through an opening in the wheel from the back side. With strap inserted through the slot in the Trac-Grabber, hold the Trac-Grabber on the wheel perpendicular to the tire tread with “D” rings on outside facing you. TIGHTLY secure one Trac-Grabber to each drive wheel. + INSTRUCTIONS FOR HOW TO GET YOUR CAR UNSTUCK Drive in REVERSE or FORWARD, whichever is the direction of least resistance and shortest direction BACK to stable terrain.*.If you are unsure, check your vehicle owner’s manual to determine whether your vehicle is front wheel drive, rear wheel drive, or all-wheel drive. “Drive” wheels are the wheels which receive power from the engine and transmission. Install Trac-Grabber on both “drive” wheels.Once the vehicle is unstuck and on solid terrain, Trac-Grabber should be removed from wheels. Trac-Grabber is not designed for extended driving.If Trac-Grabber becomes loose, stop immediately and retighten.The hubcaps should be removed prior to use. + DOES TRAC-GRABBER FIT ON VEHICLES WITH STEEL WHEELS AND HUB CAPS?Īs long as there are holes in the wheel for the strap to go th Brough they will fit on steel wheels. When mounting TRAC-GRABBER on front wheels, keep wheels as straight as possible. When attaching the Trac-Grabbers, be sure to run the strap BETWEEN the two D-Rings and attach the loose end to the velcro. Rapid spinning can reduce effectiveness AND damage the Trac-Grabbers. Apply light power to allow the Trac-Grabbers to gradually engage, lift, and move the vehicle while maintaining slow momentum. How to use the Trac-Grabber + RULES FOR USING TRAC-GRABBER
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |